ChinaAutoRegs|GB 48001-2026英文版翻译《汽车车门把手安全技术要求》
Safety Technical Requirements for Automotive Door Handle
CONTENTS
Foreword II
1 Scope 1
2 Normative References 1
3 Terms and Definitions 1
4 Technical Requirements 2
5 Test Methods 4
6 Criteria for Determination of the Same Type 6
7 Implementation of This Standard 6
Annex A (Normative) Locations of Door Handles 7
Annex B (Normative) Loading Positions for Door Handle Strength Test
1 SCOPE
This document specifies the technical requirements, test methods and criteria for determination of the same type with respect to the automotive door handle.
This document is applicable to the door handles of Categories M1 and N1 vehicles and multi-purpose goods vehicles, while this document may be used as a reference for door handles of other vehicles.
2 NORMATIVE REFERENCES
The following normative documents contain provisions which, through normative reference in this text, constitute essential provision of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendment) applies.
GB 11551 The protection of the occupants in the event of a frontal collision for motor vehicle
GB 15086 Motor vehicles' door locks and retention components performance requirements and test methods
GB 38031 Electric vehicles traction battery safety requirements
3 TERMS AND DEFINITIONS
For the purpose of this document, the terms and definitions established in GB 11551, GB 15086 and GB 38031, as well as the following apply.
3.1 doors
doors, e.g., swing doors and sliding doors, which are installed at side or back of motor vehicles and can be opened/closed for passenger access
Note: Folding doors网络平台配资, roll-up doors and improvised doors with convenient installation are not included.
竞逐配资提示：文章来自网络，不代表本站观点。
- 上一篇：最好的股票配资网站 手痒了！詹姆斯：明天要彻底休息一天 周日肯定得去打几轮高尔夫
- 下一篇：没有了
相关文章
沪深京指数
热点资讯
